General Safety Information - Funkwerk FC4 Operating Manual

General Safety Information

General safety information for all unit versions
Please read the following information prior to putting the unit and its
batteries into operation for the first time in order to ensure compliance with
the intended use and with environmental protection rules as well as safety,
reliability and system performance.
Approval and EC conformity
GB
Funkwerk Enterprise Communications GmbH herewith declares
that the products FC4 / FC4 Ex (HS) meet the basic requirements
and other relevant regulations of Directive 1999/5/EC (Radio &
Telecommunication Terminal Equipment, R&TTE).
" "
Body supervising the quality assurance system and by the explosion
protection marking
In hazardous areas with potentially explosive atmospheres, only
explosion-proof units may be used.
Observe and follow the special safety instructions for operating
explosion-proof units in hazardous areas with potentially explosive
atmospheres provided in chapter 'FC4 Ex (HS) – Supplementary
safety instructions'!
The units are intended for being connected to radio interfaces (DECT
of our Mobility Servers and, due to their design, are not suited for direct
connection to interfaces of public telecommunication networks.
Please contact your dealer or our service dept. first if there are problems in
operating your unit.
This equipment works according to the DECT TM system in the frequency
range between 1880 MHz and 1900 MHz.
You may request the EC Declaration of Conformity from our service
address or download it from the download section at
http://www.messaging.funkwerk-ec.com
DECT
TM
8
FC4 / FC4 Ex (HS) connected with Mobility Server
Explosion-proof units are provided with the CE mark of
conformity, followed by the identification no. of the Notified
.
is a registered trademark of ETSI
)
TM