Installing The Ceiling Bracket - Casablanca Tribeca Owner's Manual And Installation Manual

CAUTION: To avoid possible electrical shock, before installing your fan,
disconnect the power by turning off the circuit breakers to the outlet box
and associated wall switch location . If you cannot lock the circuit breakers
in the off position, securely fasten a prominent warning device, such as a
tag, to the service panel .
2-1 . Note: The ceiling bracket may be mounted to an existing ceiling-
-fan-rated outlet box . If the outlet box is not ceiling-fan-rated,
Drill two pilot holes into the wood support structure .
The pilot holes should be 9/64" in diameter and through the
outermost holes in the outlet box .
2-2 . Your fan comes with four neoprene noise isolators . Position the
isolators between the ceiling bracket and the ceiling by inserting
the raised areas on each isolator into the holes in the ceiling
bracket .
2-3 . Align the slotted holes in the ceiling bracket with the pilot holes
you drilled in the wood support structure . Note: The isolators
should be flush against the ceiling .
2-4 . Place a flat washer on each of the two 3" wood screws and pass
the screws through the slotted holes in the ceiling bracket into the
pilot holes you drilled .
2-5 . Tighten the screws into the 9/64" pilot holes; do not use lubricants
on the screws . Do not over tighten .
2 • Installing the Ceiling Bracket
Flat Washer
M6000-01 • 08/22/14 • Casablanca Fan Company
Isolator
Ceiling
Bracket
3" Wood
Screw
7
Step 2-2
Steps 2-3 – 2-5