How To Use The Hand-Held Steamer - Kogan KAMOP51STMA User Manual

Attach the Duster Frame to the
Telescopic Hose as follows: Align the
lock button on the Telescopic Hose
with the designated hole on the Duster
Frame. Then push in the Telescopic
House until it locks into place.
Align the lock button on the Telescopic Hose
HOW TO USE HAND-HELD STEAMER
Make sure that the STEAM MOP is unplugged.
Fill the Water Tank with water. Please refer to the
"HOW TO USE THE STEAM MOP" section in this
manual. Attach either the round nylon brush or the
round copper brush as explained in the "HOW to
assemble Hand-Held Steamer" section in this manual.
1) Select one of the following Steam Regulator
positions: 1- Low, 2- Medium, 3- High or
4- Hot Spray. You can change the Steam
Regulator position and the steam output while
operating the STEAM MOP.
2) Once the unit has been fully assembled and filled with water, plug in the
power cord to a grounded electrical outlet. Power Switch (O/ I) is in
the OFF (O) position, turns the Power Switch (O/ I) to the ON(I) position.
After approximately 30 seconds, turn on the steam regulator and adjust
the steam according to your requirement. The Mop will start emitting steam.
To stop emitting steam, turn off the steam regulator and then turn the
Power Switch (O/ I) to the OFF (O) position.
20