Kogan KAMOP51STMA User Manual page 15

Never leave the STEAM MOP unattended while plugged in.
For Best Results:
1) Sweep/vacuum floor prior to using the STEAM MOP.
The Microfiber Cloth must be clean and dry for use. To
2)
replace the cleaning cloth, proceed as follows:
Let the cleaning cloth cool down, remove cloth from unit,
replace with a new Microfiber Cloth (Optional Item) and
continue use. Select low steam regulator position.
3) To sanitize an area of your floor, leave the STEAM MOP
at high steam setting over the steam area for about
10 seconds, but no longer than 15 seconds.
Do not carry out this procedure on heat and steam sensitive floors.
Never use steam in the one spot for too long. This can cause floor surface damage.
●
Do not put hands or feet under the steam mop. The unit becomes very hot.
●
● During use, a pulsing noise may be heard indicating that the mop is producing
steam. This noise is normal.
● There may be some minor "spitting" of water mixed with the steam. This is also
normal.
● The force and heat of the steam may adversely affect certain materials. Always
check the suitability of using the steam mop on a surface by carrying out a
preliminary test on a hidden area.
The factory and its affiliated companies assume no liability for personal injury or
property damage resulting from the misuse of the STEAM MOP, including the
failure to comply with instructions contained in this User Guide or provided by the
manufacturer or distributor of the treated surface.
15