Kogan KAMOP51STMA User Manual page 14

Turning on The Steam Mop
3)
Once the unit has been fully assembled and filled with water, plug in the Power
Cord to a grounded electrical outlet. Make sure the Power Switch (O/ I) is in the OFF (O)
position. Once plugged in, turn the Power Switch (O/ I) to the ON (I) position.
After approximately 30 seconds, the steam regulator will turn on. Adjust the steam
according to your requirement. The Mop will start emitting steam.
To stop emitting steam, turns off the steam regulator and then turns the
Power Switch (O/ I) to the OFF (O) position.
If the Power Switch (O/ I) turns to the ON (I)
position, and then turn on the steam
regulator earlier than 30 seconds,
water from the previous use will not be
heated and will be forced out by steam.
This may also happened you just turn off
the Power Switch to the OFF(O) position
and left the steam regulator on from the
previous use and the unit was disconnected
by unplugging only. Make sure you turn the
unit totally OFF after each usage and then
disconnect from the electrical outlet so the unit is in the totally OFF when used next time.
Cleaning surfaces
4)
Slowly pass over the surface to be cleaned. The absorbent mop cloth picks up the dirt
loosened by the steam. Apply steam liberally. Keep a towel handy and wipe away any
excess water that may accumulate.
When the STEAM MOP stops emitting steam, simply turn OFF and unplug the appliance,
refill the Water Tank and continue cleaning.
14