Chapter 3 Initial Setup
3.1 Inserting a CompactFlash Card
UNO-4678 provides one CompactFlash slot. Following is the procedure
for the installing a CompactFlash card (Slot CN7).
Please follow these steps carefully.
1.
Remove the power cord.
2.
Unscrew the screws from the top cover of UNO-4678.
3.
Remove the top cover.
4.
Plug a CompactFlash card with your OS and application program
into a CompactFlash card slot on board.
5.
Screw back the top cover with screws.
NOTE:
3.2 Connecting Power
Connect the UNO-4678 to a 9~36 V DC power source. The power source
can either be from a power adapter or an in-house power source.
3.3 Installing a Hard Disk
Please follow these steps to install a hard disk into the UNO-4678.
1.
Remove the power cord.
2.
Unscrew the screws from the top cover of UNO-4678.
3.
Remove the top cover.
4.
Install the HDD in HDD bracket and screw on the HDD with the
four screws.
5.
Put HDD extension kit buffer on down cover of UNO-4678, and
put HDD extension kit on four buffers and screw on it.
6.
Connect the IDE flat cable to IDE connector (CN5), then connect
the other side of the connector to the hard disk.
7.
Screw back the top cover with screws.
UNO-4678 User Manual
CompactFlash disk (CN7) is Second IDE and
HDD (CN5) is Primary IDE.
16