Using The Remote Control; Auxiliary Mode; Tips On Saving Energy - Sharp AY-AP9NRH Operation Manual

USING THE REMOTE CONTROL

LOADING BATTERIES
1
Remove the battery cover.
2
Insert two batteries.
Make sure the ( + ) and ( - ) polarities are cor-
rectly aligned.
3
Reinstall the battery cover.
4
Press the RESET button using a
thin stick.
NOTE:
• The battery life is approximately 1 year in
normal use.
• When replacing the batteries, always change
both and use the same type.
• If you will not be using the unit for a long time,
remove the batteries from the remote control.
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the receiver
window and press the desired button. The
unit generates a beep when it receives the
signal.
• Make sure nothing, such as curtains, block the
signal receiver window.
• The signal effective distance is 7 m.
7 m
CAUTION:
• Do not expose the receiver window to direct
sunlight. This may adversely affect its operation.
• Use of certain fluorescent lamp in the same room
may interfere with transmission of the signal.
• Do not leave the remote control in direct
sunlight or near a heater. Protect the remote
control from moisture and shock.
OM_AY-AP9NRH_EN.indd Sec1:4 OM_AY-AP9NRH_EN.indd Sec1:4
(AAA(R03))
Battery cover
RESET button
Receiver window
EN-4

AUXILIARY MODE

Use this mode when the remote control is
not available.
TO TURN ON
Press the AUX button.
• The red OPERATION lamp (
the unit will start operating in the AUTO mode.
• The fan speed and temperature setting are
set to AUTO.
TO TURN OFF
Press the AUX button again.
• The red OPERATION lamp (

TIPS ON SAVING ENERGY

Below are some simple ways to save energy
when you use your air conditioner.
Set the proper temperature
• Setting to higher or lower then necessary tem-
perature point will result in increased power
consumption.
Block direct sunlight and prevent drafts
• Blocking direct sunlight during cooling opera-
tion will reduce power consumption.
• Close the windows and doors during cooling
and heating operations.
Keep filter clean to ensure the most ef-
ficient operation
Disconnect the power cord when the
unit is not used for an extended period
of time
• The indoor unit still consumes a small amount
of power when it is not operating.
) will light and
) will turn off.
AUX
4/17/12 12:54:10 PM 4/17/12 12:54:10 PM