Using The Remote Control; Auxiliary Mode; Tips On Saving Energy - Sharp UHL Series Operation Manual

USING THE REMOTE CONTROL

LOADING BATTERIES
1
Remove the battery cover.
2
Insert two batteries. (AAA(R03))
Make sure the (+) and (-) polarities are
correctly aligned.
3
Reinstall the battery cover.
4
Press the RESET button using a
thin stick.
NOTE:
• The battery life is approximately 1 year in
normal use.
• When replacing the batteries, always change
both and use the same type.
• If you will not be using the unit for a long time,
remove the batteries from the remote control.
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the
receiver window and press the desired
button. The unit generates a beep when
it receives the signal.
• Make sure nothing, such as curtains, block the
signal receiver window.
• The signal effective distance is 7 m.
7 m
CAUTION:
• Do not expose the receiver window to direct
sunlight. This may adversely affect its operation.
•
room may interfere with transmission of the
signal.
• Do not leave the remote control in direct
sunlight or near a heater. Protect the remote
control from moisture and shock.

AUXILIARY MODE

Use this mode when the remote control
is not available.
TO TURN ON
Press the AUX button.
• The green OPERATION lamp (
and the unit will start operating in the AUTO
mode.
• The fan speed and temperature setting are
set to AUTO.
TO TURN OFF
Press the AUX button again.
Battery cover
• The green OPERATION lamp (
RESET button

TIPS ON SAVING ENERGY

Below are some simple ways to save
energy when you use your air conditioner.
Set the proper temperature
• Setting the temperature lower than necessary
during cooling operation will result in
increased power consumption.
Block direct sunlight and prevent drafts
• Blocking direct sunlight during cooling operation
will reduce power consumption.
Receiver
• Close the windows and doors during cooling
and heating operations.
window
Disconnect the power cord when the
unit is not used for an extended period
time
• The indoor unit still consumes a small amount
of power when it is not operating.
EN-4
) will light up
) will turn off.
AUX