Setting The Error Action - Monarch 9855 Operator's Handbook Manual

S e t t i n g t h e E r r o r A c t i o n
The recovery action from an error condition is in the Setup, Supply Menu.
You can change how the printer responds to a bad scan. The choices
include normal and overstrike/continue one to five consecutive bad scans.
The overstrike pattern is created to prevent someone from using a bad label.
Selecting overstrike and continue 1x-5x sets the number of times the printer
prints an overstrike pattern on consecutively bad labels before generating an
error. The user must clear the error before operation can continue.
Do not use the overstrike action with

Peel mode

Linerless supplies

String tag supplies
For more information about the error actions, see the following table.
Error Action
Overstrike/Continue 1-5
Normal (no overstrike)
Consider this scenario when the error action is set to
overstrike/continue 3x:
If the printer errors on the first label, an overstrike pattern is printed, but the
printer attempts to reprint the image up to three times. If the third
consecutive label also generates an error, an overstrike pattern is printed;
however, the printer stops and the error message is displayed. The operator
must resolve the error condition before printing continues.
In the above example, if the third label did NOT generate an error,

the batch image is printed

the consecutive error counter is reset

the printer continues processing the batch.
4-18 Operator's Handbook
Standard
Peel with Peel
No
Yes
Verifier RFID with
No
Yes
Peel
No
Yes