Setting The Error Action - Monarch 9855 Application Notes

The following table lists the Supply Menu options:
Option
Supply Type
Ribbon
Speed
Feed Mode
Backfeed
Print Position
Supply Position
Margin Position
Cut Position
Dispense Position
Backfeed Distance
Separators
Skip Index
Knife Control
Error Action
* Depends on the supply's feed length. See "Setting the Print and Supply Positions" for
more information.

Setting the Error Action

The recovery action from an error condition is in the Setup, Supply
Menu. You can change how the printer responds to a bad label. The
choices include Normal and Overstrike/Continue one to five consecutive
bad labels. The overstrike pattern is created to prevent someone from
using the label.
Selecting overstrike and continue 1x-5x sets the number of times the
printer prints an overstrike pattern on consecutively bad labels before
generating an error. The user must clear the error before operation can
continue.
3-2 HF Application Notes
Choices
Aperture/Die Cut/Black Mark/
Continuous
No/Yes/High Energy
2.5/4.0/6.0/8.0/10.0/Default
Note: The printer pauses while
programming the RFID tag.
Continuous/On-Demand
Off/On/Extended
-450 to 450
-300 to 300
-99 to 99
-300 to 300
50 to 200
10 to 200
No/Yes/Long
No/Yes
-20 to 20
Normal
Overstrike/Continue 1x to 5x
Note: If using "overstrike," do not
use peel mode.
Default Use for RFID
Die Cut Die Cut
Yes Any
Default Any
Continuous Any
Off Conditional*
0 Conditional*
0 Conditional*
0 Any
0 Any
65 Conditional*
65 Conditional*
No Not recommended
No Not recommended
0 Any
Normal Conditional*