Changing The Position Settings; Setting The Print Position - Monarch 9855 Operator's Handbook Manual

C h a n g i n g t h e P o s i t i o n S e t t i n g s
This menu includes selections to change the print, supply, margin, cut, and
dispense positions along with the backfeed distance.
When you see
Enter print pos
[-450/450]: +0
Feed/Cut acts as a toggle switch to change the value by 10 or 1. For
example, to make the print position 23 (from the default of 0), press
Feed/Cut, then press  twice (20), press Feed/Cut again and press  three
times (23).

Setting the Print Position

This function adjusts where data prints vertically on the supply. Adjust the
print if it is too close to the top or bottom of the supply, or overtypes the pre-
printed area. One dot is 0.0049 inch.

If the data is too close to the bottom, increase the number.

If the data is too close to the top, decrease the number.
Note: Changing this setting only affects new formats sent to the printer.
4-8 Operator's Handbook