Monarch 9855 Operator's Handbook Manual page 118

757 Load supplies (supply length mismatch), because the calibrated
supply length differs by plus or minus .25 inches from the
format. Press Feed/Cut.
758 Either the supply is not seen or the on-demand sensor is
broken. Check for a label jam, clear the supply path, or reload
supplies. This error may occur if you remove a label too quickly
in the on-demand mode.
762 Low Voltage. For DC-powered printers, recharge the external
battery. For AC-powered printers, check the power inlet where
the printer is connected. The acceptable voltage range is
between 90-132 V
received, unpredictable results may occur.
763 Waiting to dispense label. Press Feed/Cut.
764 Verifier scan error (bad scan) on label when using normal (no
overstrike) mode. Press Escape/Clear to clear the error and
continue printing. The printer recalibrates (feeds a blank label)
after this error.
765 The printhead has less than 8 bad dots. The printer can shift
bar code fields to avoid bad dots. You may need to press
Escape/Clear to continue printing. Print a test label to confirm
the number of bad dots.
768 Printhead has more than 8 bad dots within the format area or is
not connected. Connect the printhead.
772 Verifier scan error (bad scan) on label or multiple labels in a row
when using overstrike and continue mode. The verifier detected
three or more bad scans in a row. Press Escape/Clear to clear
the error and continue printing. The printer recalibrates (feeds a
blank label) after this error.
773 Verifier failure. The verifier is enabled, but not connected. Make
sure the I/O cable and/or serial cable is connected to the
verifier. Refer to your verifier's Operating Instructions for more
information.
791 The printer has an error pending. Turn off the printer. Wait 15
seconds (until the power light is completely dim) and turn it back
on. Resend the packets.
10-10 Operator's Handbook
and 180-264 V
R MS
. If more or less power is
R MS