Adjusting The Footboard Assembly; Angle - Invacare Wheelchair Pronto M91 Base Owner's Manual

SECTION 7—FOOTBOARD ASSEMBLY
Mounting
Hole
Quick
Detent
Release
Ball
Pin
FIGURE 7.1 Removing/Installing the Footboard Assembly

Adjusting the Footboard Assembly

Angle

NOTE: For this procedure, refer to FIGURE 7.2.
1. Loosen the jam nut and set screw located underneath on the back of the footplate.
2. Adjust the set screw in or out to obtain the desired footboard assembly angle.
3. Thread the jam nut and washer inward until it is flush with the footboard bracket.
4. Securely tighten the jam nut and washer to secure the mounting screw in place.
FIGURE 7.2 Adjusting the Footboard Assembly - Angle
Pronto® M91™Base with SureStep®
Wheelchair Frame
Footboard
Assembly
Set Screw, Washer
and Jam Nut
50
DETAIL "A" - BOTTOM
Quick
VIEW OF FOOTBOARD
Release Pin
Outer Edge
of Tube
Footboard
Assembly
Detent Balls
Part No 1143153