Section 8-Shroud/Wheels; Replacing The Flat Free Tires On The Wheel Rim; Removing/Installing The Shrouds; Removing - Invacare Wheelchair Pronto M91 Base Owner's Manual

Base with surestep

Hide thumbs Also See for Wheelchair Pronto M91 Base:

Table of Contents

SECTION 8—SHROUD/WHEELS

After any adjustments, repair or service and before use, make sure that all attaching

hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service verify that On/Off

switch on the joystick is in the Off position.

DO NOT attempt to replace flat free tires. This procedure MUST be performed by

a qualified technician.

NOTE: During initial use of the wheelchair, the user may experience flat spots on the wheels. Flat

spots will vanish with continued use of the wheelchair.

NOTE: For this procedure, refer to FIGURE 8.1 on page 53.

1. Perform one of the following:

• Wheelchairs with Formula PTO Plus ‐ Tilt the seat back. Refer to Tilting the Seat

Assembly on page 47.

• Wheelchairs without Formula PTO Plus ‐ Remove the seat assembly. Refer to

Removing/Installing the Seat Assembly on page 46.

2. Perform one of the following:

• Top Shroud ‐ Lift up on rear edge of top shroud to release the four hook and loop

strips that secure the top shroud to the base frame (Detail "A").

• Front Shroud ‐ Turn release knob ¼‐turn to the unlocked position and lift up to

remove front shroud from base frame hooks (Detail "B").

Pronto® M91™Base with SureStep®

WARNING

Part No 1143153

Table of Contents

Show Quick Links

Table of Contents

Troubleshooting