Setting The Date And Time - Sony PDW-V1 Operation Manual

3-4 Setting the Date and
Time
When using this unit for the first time, you should set the
date and time as follows.
1
AUDIO MONITOR
L
CH-1 CH-2 CH-3 CH-4 CH-5 CH-6
R
ACCESS
SUBCLIP THUMBNAIL MENU SET
NETWORK
LOCAL
REMOTE
S.SEL
CLIP ESSENCE SYSTEM
MENU MENU
MARK
PREV PLAY NEXT STOP
IN
TOP F REV F FWD END
4
1
Holding down the SHIFT button, press the MENU
button.
The system menu appears on the monitor screen.
2
Select "DATE/TIME PRESET" using the F button or
f button, then press the g button.
The date and time setting screen appears on the
monitor, allowing you to set the following items.
• YEAR: Calendar year
• MONTH: Month
• DAY: Day
• TIME: Time
• TIME ZONE: Time zone (Difference from UTC)
3
Set the date, time and time zone.
You can change the setting of the flashing digits.
To change the flashing digits
Use the arrow buttons (G, g).
To increase or decrease the values of the flashing
digits
Use the arrow buttons (F, f) or jog dial.
4
Press the SET button.
The date, time and time zone settings are stored.
To return to the previous menu page
Press the MENU button.
To exit the menu
Press the MENU button twice in succession.
SHUTTLE JOG
CH-7 CH-8
RESET SHIFT
MARK1
OUT
MARK2
2,3 3
Note
The time zone is reset to the factory default when you
execute the maintenance menu item "RESET ALL
SETUP." You will need to set it again. The date and time
are not reset.
27

3-4 Setting the Date and Time