Playback Operation - Sony PDW-V1 Operation Manual

4-2 Playback Operation

Disc playback start position
Although this unit uses optical discs, it is designed to offer
the most convenient features of tape playback by VTRs.
One of these is the playback start position, which works in
the same way as tape, as described below.
After playback stop
The unit stops at the position where the STOP button was
pressed.
Press the PLAY button to resume playback at the stop
position.
After disc insertion
The unit stops at the position of the disc when it was most
recently ejected.
Press the PLAY button to resume playback at the most
recent position.
The playback position is saved to the disc when the disc is
ejected, which allows playback to start at that position
whenever it is loaded into any XDCAM player.
Note
This function is not available when the Write Inhibit tab of
the disc is set to the recording disabled position.
This section describes the following types of playback:
• Normal playback
Playback at normal (±1) speed
• Playback in jog mode
Variable speed playback, with the speed determined by
the speed of turning the jog dial
• Playback in shuttle mode
Variable speed playback, with the speed determined by
the angular position of the shuttle dial
Normal playback
First insert a disc.
For details of how to insert a disc, see 3-6-4 "Loading and
Unloading a Disc" on page 30.
34
4-2 Playback Operation
F f
/MARK1 button and /MARK2 button
AUDIO MONITOR
L
CH-1 CH-2 CH-3 CH-4 CH-5 CH-6
R
ACCESS
SUBCLIP THUMBNAIL MENU SET RESET
NETWORK
LOCAL
REMOTE
CLIP ESSENCE SYSTEM S.SEL
MENU MARK MENU
PREV PLAY NEXT STOP
IN
TOP F REV F FWD END
STOP button
NEXT button
PLAY button
PREV button
To start playback
Press the PLAY button.
Playback starts.
When two or more clips are recorded on the disc, they are
played back continuously.
Note
No audio is output when non-audio signals are played
back.
To jump to the next or previous clip, then start
playback
Use the PREV button, NEXT button, jog dial, or shuttle
dial.
For information about the functions of these buttons, see
4
" Playback controls" on page 15.
For details of the jog and shuttle dials, see "
shuttle control block" on page 14.
To stop playback
Press the STOP button.
If you play back to the end of the last clip
Playback automatically stops.
If, in this state, you press the PLAY button, the message
"ALARM DISC END." appears on the monitor.
To carry out playback again, move back to the desired clip
using the PREV button, jog dial or shuttle dial.
To record an essence mark
While playing back a disc, you can record essence marks
such as shot mark 1 and shot mark 2 in desired frames.
To record a shot mark 1 or shot mark 2, hold down the F/
MARK1 or f/MARK2 button and press the SET button.
Jog dial
SHUTTLE JOG
CH-7 CH-8
SHIFT
MARK1
OUT
MARK2
Shuttle dial
1
Jog/