Table of Contents
Advertisement
Message in time
Display
data display
condition
No Support!
on, limit, off
ILL. Index!
on, limit, off
FORMAT NG!
on, limit, off
DI read err
on, limit, off
DRV ADJ err
on, limit, off
a) With respect to setting of basic menu item 016
During playback
Message in time
Display
data display
condition
525/60 Disc
on, limit
625/50 Disc
on, limit
Disc Error!
on, limit, off
a) With respect to setting of basic menu item 016
During control panel operations
Message in time
Display
data display
condition
REMOTE!
on
No Disc!
on
REC INHI.!
on
REC INHI.!
on, limit
REC INHI.!
on, limit, off
REC INHI.!
on, limit, off
96
8-3 Alarms
Description
a)
A disc recorded in an unsupported
recording format was inserted.
An index file error was detected.
Automatic format failed.
A disc read error occurred.
Adjustment processing failed when a
disc was inserted.
Description
a)
An attempt was made to play back a disc
recorded with the NTSC system when
this unit is in 625 line mode (PAL
system).
An attempt was made to play back a disc
recorded with the PAL system when this
unit is in 525(U) or 525(J) line mode
(NTSC system).
Normal playback is not possible because
of a disc defect.
Description
a)
A button was pressed while the remote
control switch was set to "REMOTE."
A button was pressed with no disc
loaded.
An attempt was made to record, display
an E-E display, record an essence mark,
or add a quick scene selection sub clip.
An attempt was made to save the current
clip list on a write-protected disc.
An attempt was made to delete a clip
from a write-protected disc.
An attempt was made to format a write-
protected disc.
Action
Use a disc recorded in the MPEG IMX or
DVCAM format.
Format the disc.
For details, see 3-6-5 "Formatting a Disc"
(page 31).
Use another disc.
Try ejecting the disc and inserting it
again, or insert another disc.
Action
Use a disc recorded with the PAL
system.
Use a disc recorded with the NTSC
system.
Use another disc.
You can check the state of a disc by
checking playback condition marks (see
page 29).
Action
To operate from the control panel, wait
until control by the remote device ends
and then set the remote control switch to
"LOCAL."
Operate after inserting a disc.
Try the operation again after setting the
Write Inhibit tab to the recording enabled
position.
Advertisement
Table of Contents
