Table of Contents
Advertisement
Item number Item name
707
FORCED VERTICAL
INTERPOLATION
OFF
713
VIDEO SETUP
REFERENCE
OUTPUT LEVEL
715
VIDEO GAIN
CONTROL
716
CHROMA GAIN
CONTROL
717
CHROMA PHASE
CONTROL
718
SETUP LEVEL
(525(U)/525(J) line
modes)/BLACK
LEVEL (625 line
mode)
731
WIDE MODE
a) This is supported from firmware version 1.4.
Item number Item name
802
DIGITAL AUDIO MUTING IN
SHUTTLE MODE
823
NON-AUDIO FLAG PB
Sub-item
1
CH1/CH2
2
CH3/CH4
3
CH5/CH6
4
CH7/CH8
Menu items in the 700s, relating to video control
Settings
The "Y-add" function is normally switched on automatically during jog or
variable speed playback. This item selects whether or not to force the "Y-
add" function off.
auto: Automatically switch the "Y-add" function on.
off (forced YADD off): Force the "Y-add" function off.
The "Y-add" function is off when the unit enters stop mode.
The "Y-add" function is a circuit operation to interpolate the video signal
vertically during jog or variable speed playback for the purpose of reducing
the vertical movement of the playback picture.
Select whether to add the setup (7.5%) to the output analog video signals
(when 525(U) or 525(J) line mode is selected).
0.0%: Do not add.
7.5%: Add.
The factory default settings for each line mode are as follows:
525(U) line mode: 7.5%
525(J) line mode: 0.0%
Adjust the video output level.
–512 to 0 to 511
Adjust the chroma output level.
–512 to 0 to 511
Adjust the chroma phase.
–128 to 0 to 127
Adjust the setup level (black level).
–512 to 0 to 511
a)
Specify whether to add wide picture information recorded on a disc to the
output signal during MPEG IMX playback.
thru (through): Output the video signals of the disc being played back
without adding wide picture information.
auto: When wide picture information is detected on the disc being played
back, add wide picture information to the output video signals.
Notes
• To add wide picture information to the output signal, it is necessary, in
addition to setting this item to "auto," to operate extended menu item 703
to set line 20 (in 525 line mode) to "thru" or set line 23 (in 625 line mode)
to "thru."
• In 525 line mode, wide picture information may not be output if VITC
signal insertion position is set to line 20 in extended menu item 601 or
602.
Menu items in the 800s, relating to audio control
Settings
Set the audio muting conditions during shuttle playback.
off: Not muted.
on: Muted.
Control non-audio flags in digital audio output.
During playback (except E-E mode), set non-audio flags in digital audio
output to the following states.
on: Set to on (data is non-audio)
auto: Set as follows.
•When data is read from disc and confirmed: Follow the data.
•When data from disc is not confirmed: Maintain current state.
81
7-3 Extended Menu
Advertisement
Table of Contents
