Kingsman ZV3600 Installation Instructions Manual page 8

Hearth
A hearth is not mandatory but is recommended for aesthetic pur-
poses. We recommend a non-combustible hearth projecting out
12" (305mm) or more in front of the fireplace.
Clearance to Combustibles
Back (from Standoffs) 0 inches/0 mm
Side (from standoffs) 0 inches/0 mm
Floor 0 inches/0 mm
Top (from standoffs) 0 inches/0 mm
Top (from front of unit) 0 inches/0 mm
Note: See Mantel Chart
Mantels
Depending on the width of the fireplace mantel, it may be
installed higher or lower from the top of the fireplace opening.
See drawings for proper installation height of your combustible
mantel. Non-combustible mantels may be installed at any height
above the fireplace opening.
Non combustible materials such as brick, tile, etc. can extend up
to or over the front face of the fireplace (NO PORTION OF
GRILL AREA OR DOOR AREAS CAN BE COVERED).
Combustible material can extend flush to unit up to the top, bot-
tom and sides of fireplace to stand-offs.
If slim line brass surround is used, brick, tiles or other NON-
COMBUSTIBLE materials may extend past the front of unit giv-
ing a recessed appearance. For COMBUSTIBLE materials
extending in front of fireplace consult "Mantel and Mantel Leg
Drawings".
If wide brass surround is used finish materials must be flush with
front of unit.
Note: When using paint or lacquer to finish the mantel, such
paint or lacquer must be heat resistant (250˚F) to prevent
discoloration.
Warning: Combustible objects must not be placed on
a non-combustible mantel unless the non-combustible mantel
meets the minimum height and width requirements for a
combustible mantel.
8