Table Of Contents - Jøtul GI 350 DV Scan 65i Installation And Operation Instructions Manual
Direct vent gas fireplace insert
Hide thumbs
Also See for GI 350 DV Scan 65i:
- Installation and operation instructions manual (32 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Table of Contents
Installation & Service Tools .......... 2
Specifications ....................................4
General Information ........................ 5
Safety Information ..........................6
Fireplace Requirements .............. 7
Hearth Protection ..........................8
Clearances ........................................8
Masonry Fireplaces .....................10
Prefabricated Fireplaces ............... 11
Vent Requirements .......................13
Gas Connection ............................. 14
Gas Pressure....................................15
Fuel Conversion ............................. 16
Wall Thermostat ........................... 18
Remote Control ............................ 18
Blower Power Requirement ....... 18
Optional Wall Panel Kits ............. 19
Log Set Installation ..................... 20
System Check..................................21
Surround Assembly ......................22
Burner Controls ............................ 23
Blower Controls ...........................24
Annual Cleaning ...........................24
Glass Replacement .......................25
Illustrated Part Breakdown ......... 26
Replacement Parts List .................. 27
Service Log ...................................... 30
Lighting Instructions ......................31
Unpacking the Fireplace
1. The Log Set is packaged inside the firebox. Remove
2. Follow the instructions in this manual for insert in-
Left Latch
Release
......28
Figure 1. Pull each Spring Latch out and down to
disengage it from the Glass Frame.
the Glass Panel Frame to unpack the firebox:
• Locate the Glass Frame Latch Release tool packed
in the bag with this manual.
• See the cut-away view in fig. 1 below to locate
the right and left spring latches on the underside
of the firebox floor. Release each latch by engaging
the tangs of the tool with the latch throat, pulling
it forward and down.
• Pull the Glass Frame away from the Firebox and
lift to disengage it from the retaining lip at the top
of the firebox. Set the glass out of the way.
• Remove the Log Set. Do not unpack the log parts
until you are ready to install them.
stallation and optional equipment as appropriate.
Release Tool
Latch
Advertisement
Table of Contents
