Jøtul C 350 Installation And Operating Instructions Manual
Winterport
fireplace insert
Hide thumbs
Also See for C 350:
- Installation and operating instructions manual (24 pages) ,
- Installation and operating instructions manual (24 pages)
Related Manuals for Jøtul C 350
Summary of Contents for Jøtul C 350
- Page 1 Jøtul C 350 Winterport Jøtul C 350 Winterport Fireplace Insert Installation and Operating Instructions for the United States & Canada Keep these instructions for future reference.
- Page 2 Jøtul C 350 Winterport Accepted For Use City of New York Department of Buildings MEA 429-07-E Jøtul North America, Inc. NOTICE: YOU SHOULD CONSULT THE AUTHORITY HAVING JURISDICTION IN YOUR LOCALE (SUCH AS MUNICIPAL BUILDING DEPARTMENT, FIRE DEPARTMENT, FIRE PREVENTIOIN BUREAU, ETC.) BEFORE INSTALLATION TO DETERMINE THE NEED TO OBTAIN A PERMIT.
-
Page 3: Table Of Contents
Specifications The serial number and manufacturing date are Jøtul C 350 Winterport Fireplace Insert ....6 located on the permanent label on the back of the firebox and also at the front of the blower compartment. -
Page 4: Standards And Safety Notices Standards / Codes
Check Building Codes Standards & Approvals When installing, operating and maintaining your The Jøtul C 350 Fireplace Insert has been tested Jøtul C 350 Fireplace Insert, follow the guidelines and listed to: U.S: ANSI/UL 1482 presented in these instructions, and make them Canada: CAN/ULC-S628-93 available to anyone using or servicing the stove. -
Page 5: Safety Notices
• BURN SOLID WOOD FUEL ONLY We strongly urge you to have your authorized Jøtul • DO NOT USE CHEMICALS OR FLUIDS TO START dealer install your new Jøtul C 350 Fireplace Insert. THE FIRE. DO NOT BURN Garbage OR FLAM- MABLE FLUIDS. -
Page 6: Specifications
Fuel: 20” Logs Heat Output 40,000 BTU/hr. (4.1 kg/hr.) The Jøtul C 350 Winterport Fireplace Insert meets U.S. EPA emission limits for wood heaters sold after July Heating Capacity : Up to 1,300 sq. ft. 1990, and is tested and listed to ANSI/UL 1482, and... -
Page 7: Installation
Factory-Built Fireplace Requirements Masonry Fireplace Requirements • The entire fireplace and chimney must be The Jøtul C 350 Winterport may be installed into a cleaned and inspected before installation. The factory-built fireplace with the following condi- system must meet local building code require- tions: ments. -
Page 8: Hearth Protection
Jøtul C 350 Winterport Hearth Protection Requirements The floor area in front of fireplace insert must be Min. protected from live sparks and radiant heat. 16” from door opening • Materials: Hearth protection must be non combustible insulating board, or the equiva- Combustible lent mortared masonry material. -
Page 9: Clearance To Combustibles
Jøtul C 350 Winterport Mantel Clearances Clearance to Combustible Materials Clearance reduction to mantel construction may be • There may be no combustible materials located made in conformance to NFPA 211 or CAN/CSA B365. anywhere within 36” (914 mm) of the front of the fireplace insert. -
Page 10: Chimney Connection
Jøtul C 350 Winterport Chimney Connection This insert must be connected to a code-approved A 6”, 7”, or 8” stainless steel liner, extending the masonry chimney or listed factory-built fireplace full height of the chimney, is required for all installa- chimney with a direct (positive) flue connector into tions where the flue tile is greater than 8”... -
Page 11: Leveling Bolts
Jøtul C 350 Winterport Installing the Fireplace Insert Installation 1. Remove the existing damper and linkage compo- Leveling Bolts nents from the fireplace. Alternatively, you can wire the damper plate to lock it in the open The leveling bolts are used to compensate for position. -
Page 12: Firebox Installation
Jøtul C 350 Winterport Install the Riser Bar Surround 1. If appropriate to your installation (see pg. 8), Bracket position the riser bar centered within the fire- place as shown in fig. 10. The forward ends of the Riser Bar should be aligned within 1/2 inch of the fireplace face. -
Page 13: Surround Assembly
Jøtul C 350 Winterport Figure 12. M6 x 10 Surround Panel assembly viewed Set Screw from backside. Right Breastplate Left Breastplate T T T T T ools R ools R ools R ools R ools Requir equir equir equir equired: •... -
Page 14: Operation
Jøtul C 350 Winterport Operation Air Control Settings A single lever regulates the Primary Air flow that Read the following section carefully before building controls the intensity of the fire and consequent a fire in your fireplace insert.. heat output and burn time. This lever is located... -
Page 15: Starting / Maintaining The Fire
Jøtul C 350 Winterport Starting and Maintaining a Fire Keep logs behind Burn only solid wood directly on the bottom plate of Andirons the stove. Do not elevate the fire in any way. 1. Set the Air Control Lever in the full open position. -
Page 16: Blower
SWITCH NOTE: Terminals and switch markings are on opposite ends of the switch. See below. HIGH Manual Circuit Auto Circuit Terminal Terminal Auto Switch Manual Switch Position Position Figure 17. Blower and speed controls. Figure 18. C 350 Wiring diagram. -
Page 17: Maintenance
The container of ashes should be placed on a Replace glass only with part # 156069 noncombustible floor or on the ground, well away specifically designed for the Jøtul C 350 from all combustible materials, pending final Winterport Fireplace insert. Do not use disposal. -
Page 18: General Maintenance
Jøtul C 350 Winterport General Maintenance Regular maintenance will assure proper perfor- Gaskets mance and prolong the life of your fireplace insert.. Check door and glass gaskets for seal integrity. The following procedures do not take long and are The gaskets should be soft enough to be somewhat generally inexpensive. - Page 19 Jøtul C 350 Winterport...
-
Page 20: Illustrated Parts Breakdown Parts List
Jøtul C 350 Winterport Jøtul C Jøtul C Jøtul C Jøtul C Jøtul C 350 W W W W W in in in in interpor terpor terpor terpor terport t t t t Illustr Illustr Illustr Illustr Illustra a a a a ted P... -
Page 21: Parts List
Jøtul C 350 Winterport Jøtul C 350 Winterport Parts List No..Description Description P P P P P ar ar ar ar art t t t t Number Number Number Description Description Description Number Number Rope Gasket, Fiberglass LD .360 x 78” - Frnt Plate 100038 No. -
Page 22: Miscellaneous Replacement Parts
Jøtul C 350 Winterport Appendix A Baffle Plate Removal Door Knob Installation The baffle assembly is easily removable following The Door Knob components are included in a these steps: separate bag contained within the Miscellaneous Kit included with the firebox. Install the parts in the 1) The Secondary Air Tube must be removed order shown in fig. -
Page 23: Baffle Assembly
Jøtul C 350 Winterport Jøtul C Jøtul C Jøtul C 350 W W W W W in in in in interpor Jøtul C Jøtul C terpor terpor terpor terport t t t t Options Options Options Options Options Extended Surround Panel, Matte Black Paint 156055 Extended Surround Panel, Jøtul Iron Paint... - Page 24 Jøtul C 350 Winterport This appliance must be installed in conformance with local and national building regulations. It is important that the these instructions be carefully read and understood before beginning the installation. Jøtul pursues a policy of continual product development. Consequently, products may differ in specification, color or type of accessories from those illustrated or described in various publications.
Need help?
Do you have a question about the C 350 and is the answer not in the manual?
Questions and answers