Advertisement

Quick Links

Jøtul C 350 Winterport 138376_Rev_J
1 /2 / 12
Jøtul C 350
Winterport
Fireplace Insert
Installation and Operating Instructions
for the United States & Canada
Keep these instructions for future reference.
1

Advertisement

Table of Contents
loading

Summary of Contents for Jøtul Winterport C 350

  • Page 1 Jøtul C 350 Winterport 138376_Rev_J 1 /2 / 12 Jøtul C 350 Winterport Fireplace Insert Installation and Operating Instructions for the United States & Canada Keep these instructions for future reference.
  • Page 2 Jøtul C 350 Winterport 138376_Rev_J 1 / 2 / 12 NOTICE: YOU SHOULD CONSULT THE AUTHORITY HAVING JURISDICTION IN YOUR LOCALE (SUCH AS MUNICIPAL BUILDING DEPARTMENT, FIRE DEPARTMENT, FIRE PREVENTIOIN BUREAU, ETC.) BEFORE INSTALLATION TO DETERMINE THE NEED TO OBTAIN A PERMIT.
  • Page 3: Table Of Contents

    Jøtul C 350 Winterport 138376_Rev_J 1 /2 / 12 Table of Contents Standards and Safety Notices For Your Records... Standards / Codes ............4 Record the following information to help your Safety Notices ............... 5 dealer determine what you will need should Preparation ..............
  • Page 4: Standards And Safety Notices Standards / Codes

    Jøtul C 350 Winterport 138376_Rev_J 1 / 2 / 12 Installation and Operation Instructions for USA/Canada Installation et fonctionnement pour Canada SAFETY NOTICE: IF THIS SOLID FUEL ROOM HEATER IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. FOR YOUR SAFETY, FOLLOW THE INSTALLATION DI- RECTIONS.
  • Page 5: Safety Notices

    Jøtul C 350 Winterport 138376_Rev_J 1 /2 / 12 Installation Safety Notices Preparation • BURN SOLID WOOD FUEL ONLY We strongly urge you to have your authorized Jøtul • DO NOT USE CHEMICALS OR FLUIDS TO dealer install your new Jøtul C 350 Fireplace Insert. START THE FIRE.
  • Page 6: Specifications

    Jøtul C 350 Winterport 138376_Rev_J 1 / 2 / 12 Jøtul C 350 Winterport Specifications Performance Maximum Heat Output based on total kilograms of dry wood burned in a one hour period. Under Fuel: 20” Logs specific EPA test conditions, this heater has gener- Heat Output 40,000 BTU/hr.
  • Page 7: Installation

    Jøtul C 350 Winterport 138376_Rev_J 1 /2 / 12 Installation Factory-Built Fireplace Requirements Masonry Fireplace Requirements The Jøtul C 350 Winterport may be installed into a • The entire fireplace and chimney must be cleaned factory-built fireplace with the following conditions: and inspected before installation.
  • Page 8: Hearth Protection

    Jøtul C 350 Winterport 138376_Rev_J 1 / 2 / 12 Hearth Protection Requirements The floor area in front of fireplace insert must be protected from live sparks and radiant heat. Min. • Materials: Hearth protection must be non 16” from door combustible insulating board, or the equiva- opening lent mortared masonry material.
  • Page 9: Clearance To Combustibles

    Jøtul C 350 Winterport 138376_Rev_J 1 /2 / 12 Mantel Clearances Clearance to Combustible Materials Clearance reduction to mantel construction may be • There may be no combustible materials located made in conformance to NFPA 211 or CAN/CSA B365. anywhere within 36” (914 mm) of the front of the fireplace insert.
  • Page 10: Chimney Connection

    Jøtul C 350 Winterport 138376_Rev_J 1 / 2 / 12 U.S. Requirement: The insert is connected to a listed stainless steel flexible connector that extends into the first chim- ney flue tile liner. A sealed block-off plate must be chimney connection components - these materials installed at the damper area of the existing fireplace.
  • Page 11 Jøtul C 350 Winterport 138376_Rev_J 1 /2 / 12 Installing the Fireplace Insert Chimney Connection Leveling Bolts This insert must be connected to a code-approved The leveling bolts are used to compensate for ir- masonry chimney or listed factory-built fireplace regular hearth surfaces.
  • Page 12: Firebox Installation

    Jøtul C 350 Winterport 138376_Rev_J 1 / 2 / 12 Install the Riser Bar Surround 1. If appropriate to your installation (see pg. 8), posi- Bracket tion the riser bar centered within the fireplace as shown in fig. 10. The forward ends of the Riser Bar should be aligned within 1/2 inch of the fireplace face.
  • Page 13: Surround Assembly

    Jøtul C 350 Winterport 138376_Rev_J 1 /2 / 12 Figure 12. M6 x 10 Surround Panel assembly viewed Set Screw from backside. Right Breastplate Left Breastplate Tools Required: • 10 mm socket or wrench Hang Tabs Hang Tabs Right Leg Left Leg All fasteners are M6 x 10 mm hex head bolts,...
  • Page 14: Operation

    Jøtul C 350 Winterport 138376_Rev_J 1 / 2 / 12 Operation Air Control Settings A single lever regulates the Primary Air flow that Read the following section carefully before building controls the intensity of the fire and consequent heat a fire in your fireplace insert.. output and burn time.
  • Page 15: Starting / Maintaining The Fire

    Jøtul C 350 Winterport 138376_Rev_J 1 /2 / 12 Starting and Maintaining a Fire Keep logs behind Burn only solid wood directly on the bottom plate of Andirons the stove. Do not elevate the fire in any way. 1. Set the Air Control Lever in the full open position. 2. Crumple several sheets of newspaper directly on the bottom plate..
  • Page 16: Blower

    Jøtul C 350 Winterport 138376_Rev_J 1 / 2 / 12 It is also important to remember that chimney size, temperature and height all affect draft which in  THIS BLOWER MUST BE ELECTRI- turn affects the formation of creosote. An exterior CALLY GROUNDED IN ACCOR- chimney, whether masonry or prefabricated steel, DANCE WITH LOCAL CODES OR, IN will be exposed to cold outside temperatures, and THE ABSENCE OF LOCAL CODES,...
  • Page 17: Maintenance

    Jøtul C 350 Winterport 138376_Rev_J 1 /2 / 12 Maintenance Glass Replacement Always operate the doors slowly and cautiously to avoid cracking or breaking the glass. Never use the Ash Removal door to push wood into the firebox. If the glass becomes cracked or broken follow the replacement Always wear stove gloves when handling ashes.
  • Page 18: General Maintenance

    Jøtul C 350 Winterport 138376_Rev_J 1 / 2 / 12 General Maintenance Regular maintenance will assure proper perfor- Gaskets mance and prolong the life of your fireplace insert.. Check door and glass gaskets for seal integrity. The following procedures do not take long and are The gaskets should be soft enough to be somewhat generally inexpensive.
  • Page 19 Jøtul C 350 Winterport 138376_Rev_J 1 /2 / 12 Blower Maintenance In order to ensure that the blower delivers many years of reliable performance, you should inspect it regularly and clean it of any household dust and debris that may have accumulated. This is particularly important if there are any pets in the home.
  • Page 20 Jøtul C 350 Winterport 138376_Rev_J 1 / 2 / 12 Jøtul C 350 Winterport Illustrated Parts Diagram Figure 20.
  • Page 21: Parts List

    Jøtul C 350 Winterport 138376_Rev_J 1 /2 / 12 Jøtul C 350 Winterport Parts List Description Part Number Description Part Number Rear Shroud 220904 Rope Gasket, Fiberglass LD .360 x 78” - Frnt Plate 100038 Screw, #8 x 5/8” Hex Slt 117917 Air Slider, Matte Black Paint 156092...
  • Page 22: Miscellaneous Replacement Parts

    Jøtul C 350 Winterport 138376_Rev_J 1 / 2 / 12 Appendix A Door Knob Installation Baffle Plate Removal The baffle assembly is easily removable following The Door Knob components are included in a sepa- rate bag contained within the Miscellaneous Kit in- these steps: cluded with the firebox.
  • Page 23: Warranty Statement

    Jøtul C 350 Winterport 138376_Rev_J 1 /2 / 12 Jøtul C 350 Winterport Warranty This warranty policy applies to wood-burning products identified by without limitation, use that is not in conformance with the operat- Jøtul trade names, as set forth below. ing instructions contained in this owners manual.
  • Page 24 Jøtul C 350 Winterport 138376_Rev_J 1 / 2 / 12 This appliance must be installed in conformance with local and national building regulations. It is important that the these instructions be carefully read and understood before beginning the instal- lation. Jøtul pursues a policy of continual product development. Consequently, products may differ in specification, color or type of accessories from those illustrated or described in various publications.

Table of Contents