Installation
CONTROL WIRING TERMINAL
BLOCK: Receives control wires for a
variety of functions, including
generator control. See facing page for
terminal descriptions.
AC TERMINAL BLOCK
Receives AC input wires
for two input sources (L1,
L2, and neutral for each).
Also receives AC output
wires (L1, L2, and neutral).
All neutral wires are
electrically common. See
page 22 for instructions.
WARNING: Shock Hazard
After installation, do not remove the covers while the inverter has any source of power. See the Operator's
Manual for the shutdown procedure before removing the covers.
18
Figure 13 AC Terminals, Ports, and Ground Bus
REMOTE and BATTERY TEMP
PORTS: Receive the RJ45 and
RJ11 plugs from the MATE3
system display and Remote
Temp Sensor. See page 25 for
instructions.
GROUND BUS
Receives ground wires
from multiple
locations. See page 19
for instructions.
900-0160-01-00 Rev A