Operation; Assembly; Fitting The Machine Table; Tensioning The Saw Blade - Titan TTB364BDS Safety And Operating Manual

OPERATION INSTRUCTIONS
Warning: before using your band saw,
read the instruction manual carefully.
before putting the machine into operation
1. Make sure the machine stands securely, i.e.
bolt it to a workbench or solid base. There are two
holes for this purpose in the machine foot.
2. All covers and safety devices have to be properly
fixed before the machine is switched on.
3. It must be possible for the blade to run freely.
4. When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
5. Before you actuate the On/Off switch, make
sure that the saw blade is correctly fitted and that
the machine's moving parts run smoothly.
6. Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.

ASSEMBLY

WARNING: Pull out the power plug before
carrying out any maintenance, resetting or
assembly work on the bandsaw!
1. Fitting the machine table (See Fig1 &
Fig3)
1) Undo the fixing handle (18)
2) Remove the retaining screw (a).
3) Place the work table (20) on the machine frame
(13) from the right. Please note that the saw blade
(23) is positioned in the center of the table.
4) The dial scale (19) of the table (20) must be
fitted in the guide on the machine frame (13)
5) Screw on the fixing handle (18) again to clamp
the saw table (20) in place.
6) Insert the retaining screw (a) and tighten. Please
note that the wing nut (b) of the retaining screw
(a) is located on the underside of the table.
2. Tensioning the saw blade (See Fig4)
1) note:
Remove the tension from the saw blade if the
band saw is not going to be used for some time.
Be sure to re-tension the saw blade before you
BAND SAW
Fig 1
Fig 2
a
Fig 3
Fig 4
TTB364BDS
b