Adjusting The Upper Band Guide; Adjusting The Work Table To 90 Degree; Blade Selection - Titan TTB364BDS Safety And Operating Manual

Fig 8
7
d
20 19
18
Fig 9
41 42
Fig 10
6) Move the guide pins (29) towards the blade so
that there is a gap of approx. 0.5mm between the
guide pins (29) and the blade (23). The blade must
not jam.
7) Re-tighten the hex. screws (38).
8) Turn the lower band pulley (8) several times in
a clockwise direction.
9) Check the setting of the guide pins (29) again
and re-adjust if necessary.
IMPORTANT! After completing the above
adjustments, the upper (6) and lower (34) band
guards must be refitted.
5. Adjusting the upper band guide (7) (See
Fig8)
1) Undo the fixing handle (18).
2) Turn the setting wheel (12) to lower the band
guide (7) as close as possible to the workpiece to
be cut. The gap should be approx. 2-3 mm.
3) Re-tighten the fixing handle (18).
4) Check the setting before each cut and re-adjust
if necessary.
6. Adjusting the work table (20) to 90° (See
Fig9 & 10)
1) Move the upper blade guide (7) to the top.
2) Undo the fixing handle (18).
3) Set the angle between the blade (23) and the
table (20).
4) Turn the setting knob (12) to tilt the work table
(20) until it is at an angle of exactly 90° to the
20 blade (23).
5) Re-tighten the fixing handle (18).
6) Undo the nut (42).
7) Adjust the hex. screw (41) until there is contact
with the machine frame (13).
8) Re-tighten the nut (42) to fasten the hex. screw
(41).
9) Undo the recessed head screw locked on the
scale pointer (17) to position the angle scale
pointer (17) on the 0° mark on the dial scale (19).

7. blade selection

The blade supplied with the band saw is designed
for all-purpose use. When you select a blade you
should have regarded to the following criteria:
1) Use a narrow blade to cut tighter radii than you
can with a wider blade.
2) Wide blades are used to saw straight cuts. This