Adjusting The Lower Support Bearing; Adjusting The Upper Guide Pins; Adjusting The Lower Guide Pins; Upper Support Bearing - Titan TTB364BDS Safety And Operating Manual

(28 + 29).
Undo the fixing knobs (2) to open the left side
cover (3).
Undo the hex screws (32) and remove the blade
guard (6).

4.1. Upper support bearing (30)

1) Undo the hex screw (33).
2) Move the support bearing (30) so that it is
almost touching the blade (23). There should be a
gap of approx. 0.5mm.
3) Re-tighten the hex screws (33).

4.2. Adjusting the lower support bearing

(31)
Adjust in the same way the upper support bearing
adjusted.
The blade (23) is only supported by the support
bearings (30) during cutting.
When idle the blade should not touch the ball
bearings.

4.3. Adjusting the upper guide pins (28)

1) Undo the hex screw (35).
2) Move the mount (36) of the guide pins (28) so
that there is a gap of approx. 1mm between the
front edge of the guide pins (28) and the gullet of
the blade in front.
3) Re-tighten the hex screw (35).
4) CAUTION! The blade will be rendered useless
if the teeth touch the guide pins while the blade
is running.
5) Undo the hex screws (37).
6) Move the guide pin (28) towards the blade so
that there is a gap of approx. 0.5 mm between
the guide pins (28) and the blade (23). The blade
must not jam.
7) Re-tighten the hex screws (37).
8) Turn the upper band pulley (5) several times in
a clockwise direction.
9) Check the setting of the guide pins (28) again
and re-adjust if necessary.

4.4. Adjusting the lower guide pins (29)

1) Undo the hex screw (40).
2) Move the mount (49) of the guide pins (29) so
that there is a gap of approx. 1mm between the
front edge of the guide pins (29) and the gullet of
the blade in front.
3) Re-tighten the hex screw (40).
4) CAUTION! The blade will be rendered useless
if the teeth touch the guide pins while the blade
is running.
5) Re-tighten the hex screws (38).
BAND SAW TTB364BDS