Table of Contents
Advertisement
GLASS DOOR
REMOVAL
1) Remove the 8 screws that secure the
glass door.
2) Pull the door slightly out on an angle and
then lift up and pull completely out.
3) PG131 & PG121LC/PG121RC Corner Mod-
el: Remove the 6 screws that secure the
glass door and repeat step 2.
Masport PG121/PG131 Zero Clearance Room Sealed Gas Fireplace
FINISHING TRIM
1) Slide the Side Finishing Trim up into the slot
in the top flange of the fireplace. Push tight
against the magnet at the base of the unit.
Slide Trim into
Push trim tight
against magnet.
2) Slide the Corner Finishing Trim up into the
slot in the top flange of the fireplace. Push
tight against the magnet at the base of the
unit.
Slide Trim into
Push trim tight
against magnet.
INSTALLATION
LOUVERS & GRILLS
1) Attach the screws provided to the top left
and right corners.
NOTE: Do not tighten the screw entirely,
ensure that some room is left to be able
to hang the grill or louver over the screw.
slot.
2) Hang the Top Louver or Grill onto the 2
screws in the top fireplace opening.
3) Attach the Bottom Louver or Grill to the
hinges on the bottom flange of the fireplace.
PG121 & PG131 Corner Models
4) Attach the screws provided to the top and
slot.
bottom, left and right corners similar to step
1.
5) Hang the top and bottom louver or grill onto
the screws in the top and bottom, left and
right sides of the fireplace opening.
The Top and Bottom Side Louver or Grill is
installed the same way.
27
Advertisement
Table of Contents
