Subnet Mask - Muratec MFX-2030 Network Manual

Subnet.Mask
Subnet mask is the mask value that specifies the IP address range of the subnet.
NOTE: If your server is DHCP compliant, the subnet mask will be assigned auto-
matically and it cannot be edited. If the DHCP server is not installed on your
network, you can assign a Subnet mask manually as described below.
To assign a Subnet mask manually:
1
Open the TCP/IP setting menu display. (Refer to page 2-2.)
2
Press [DHCP Setting], then press [OFF] and [Enter].
3
Press [Subnet Mask].
4
Enter the appropriate IP address of the subnet mask using the numeric keys.
Press the arrow keys to navigate the IP address fields. Press the [Clear] to
delete a number.
5
Press [Enter]. The display returns to the TCP/IP setting menu.
You may configure additional settings.
To return to the Standby mode, press [Reset].
6
After you have completed registering the network settings, the machine
should be rebooted to enable the new settings. To reboot the machine, turn the
machine "Off" and after three or more seconds, turn the machine back "On"
2-6 Network settings