Workgroup - Muratec MFX-2030 Network Manual

WorkGroup

Enter an existing workgroup name to identify the group of computers that your
machine is associated with.
1
Open the SMB setting menu display. (Refer to page 2-10.)
2
Press [WorkGroup].
3
Enter an existing workgroup name.
NOTE: • If there is not workgroup in your network, enter a domain name or NetBIOS
domain name of your network. For example, if your domain is muratec.local,
enter "muratec" in the Workgroup setting. Consult your network administra-
tor about the domain name.
4
Press [Enter]. The display returns to the SMB setting menu.
You may configure additional settings.
To return to the Standby mode, press [Reset].
5
After you have completed registering the network settings, the machine
should be rebooted to enable the new settings. To reboot the machine, turn the
machine "Off" and after three or more seconds, turn the machine back "On"
Network settings
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
2-13