Muratec MFX-2030 Network Manual page 104

Item Description
Start Service Set the SNMP agent service to enable or disable.
Setting
Agent Identifi- "Contact Destination"
cation Enter the administrator name.
Up to 255 characters can be entered.
"Name"
Enter the machine model name.
Up to 40 characters can be entered.
"Location"
Enter the location where the machine is installed.
Up to 100 characters can be entered.
"Name" and "Location" fields are shared with "Device Set-
ting" in "Management Information" column. This means
if you change these fields, the fields in Device Setting will
also be changed, and vice versa.
Security Enter the community name.
The community name is used to check whether incoming
SNMP requests have the correct community name or not.
The community name is displayed as ••••• for security
reasons.
The default community name is "public".
You can enter up to 20 characters for the community name.
For detail, refer to the documentation of the SNMP man-
ager you are using.
If you want to specify the hosts from which to accept the
SNMP request, check "Accept requests from specified
hosts" and enter the IP address and community name.
Up to three hosts can be registered.
Initialize Initialize the SNMP settings. The settings will return to
the factory default setting.
The "Name" and "Location" will not be initialized. To
initialize them, click [Device Settings] from "Management
Information" column, then click [Initialize].
3
When you are finished, click [Save] to save the settings.
Using the Web Browser
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
5-45