Loading For Peel Mode; Loading For Fan-Fold - Avery Dennison Monarch Sierra Sport4 9493 Operator's Handbook Manual

Loading for peel mode

Peel mode removes the label from the liner as it prints. It is only for labels. This mode allows
you to apply the label immediately. When the printer is in on-demand mode, the next label prints
automatically when the previous one is removed.
Open the printer. See "Opening & Closing the Printer" for more information.
1.
Remove the tape from a new roll of supply.
2.
Push the supply holder tabs apart to widen the supply holders. Insert a roll of supplies so it
3.
unwinds from the top.
Pull out the supply so that a few inches extend past the front of the printer. Center the
4.
supply across the platen roller.
Raise the supply door back to the upright position but do not close the printer.
5.
Remove a couple of labels from the liner. Feed the liner over the platen roller, over the peel
6.
bar, and under the peel edge as shown. Center the supply under the peel edge.
Close the printer completely. See "Opening & Closing the Printer" for more information.
7.
Lightly tug on the liner to remove the slack.
8.
Turn on the printer if it is not already on.
9.
Press under
10.
supply error, see Chapter 4, "Troubleshooting."
The label separates from the liner.

Loading for fan-fold

Use these instructions for fan-fold supplies only.
Open the printer. See "Opening & Closing the Printer" for more information.
1.
Adjust the 4.8-inch (122 mm) core to the width of your fan-fold supplies
2.
by pushing or pulling the supply guides on each side of the core.
The guides move in 0.03-inch (0.8 mm) increments.
2-6 Operator's Handbook
once or twice to advance the labels under the printhead. If you receive a
Peel Bar
Peel Edge
Liner