Avery Dennison Monarch Sierra Sport4 9493 Operator's Handbook Manual page 12

Remove the clear wrap from a new ribbon and tear it at the perforation.
6.
A
Gear
Latches
Make sure the preprinted side of the ribbon faces out. Slide the ribbon reel onto the long
7.
spool with the foam washer and the take-up reel onto the short spool. Thread the ribbon
around the ribbon guide. Turn the ribbon roll slightly to take up some of the excess slack, if
necessary.
Ribbon
Guide
Do not wind the ribbon too tightly. Do not touch the ribbon with your fingers. Do not wrinkle
or twist the ribbon.
Note: If you are using a 2-inch or 3-inch ribbon, push the core of the ribbon roll onto the spool
of the cassette but do not force it or you may damage the foam washer. Do not touch
the ribbon with your fingers!
2-4 Operator's Handbook
Take-up Core
New Ribbon
A
B
Foam Washer