Mounting - Chauvet COLORado 1 Tour Quick Start Manual

Setup

Mounting

Orientation
Rigging
Procedure
Product
Mounting
Diagram
6
Read the safety notes at the beginning of this guide and follow their
recommendations before mounting this product.
You can mount this product in any safe position.
The COLORado™ 1 Tour consists of a sealed housing with a double
bracket mounting yoke. It has two DMX signal sockets (DMX In/out), and
two Neutrik POWERCON sockets (Power In/Out).
CHAUVET® recommends following the general guidelines below when
mounting the COLORado™ 1 Tour
·
When selecting an installation location, consider ease of access to the
product for operation, programming adjustments and routine
maintenance.
·
Always mount this product making sure that there is adequate room
around it for ventilation.
·
Do not expose this product to extreme temperature changes.
·
Maximum ambient temperature (Ta) is 104° F (40° C). Do not operate
this product at a higher temperature.
·
If mounting this fixture overhead, make sure that the location where you
are mounting it can support its weight. Please see the Technical
Specifications section of this guide for the weight requirement of this
product.
This fixture includes a mounting yoke to which you can attach one or two
rigging clamps. You must supply your own "C" or "O" clamps and make sure
that they are capable of supporting the weight of this fixture. CHAUVET®
recommends using at least two mounting points per fixture.
Overhead Mounting
Secure the safety cable
using the passageway on
the back of the fixture.
COLORado™ 1 Tour Quick Start Guide Rev. 03
Floor Mounting