Table of Contents
Advertisement
3. Setup
AC Power
Power
Linking
AC Plug
Fuse
Replacement
Lens
Assembly
COLORado™ 1 Tour Quick Start Guide Rev. 03
The COLORado™ 1 Tour has an auto-ranging power supply that can work
with an input voltage range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per
the specifications in this guide, the product's user manual or on the
product's sticker.
Always connect the COLORado™ 1 Tour to a protected circuit with an
appropriate electrical ground to avoid the risk of electrocution or fire.
To determine the power requirements for the COLORado™ 1 Tour see the
sticker affixed to the product. Alternatively, you may refer to the Technical
Specifications chart in the Technical Information chapter of this guide.
The listed current rating indicates the maximum current draw during normal
operation. Please refer to the Sizing the Circuit Breakers section in the
Appendix chapter of the COLORado™ 1 Tour user manual.
Never connect the COLORado™ 1 Tour to a rheostat (variable resistor)
or dimmer circuit, even if the rheostat or dimmer channel serves only
as a 0 to 100% switch.
The COLORado™ 1 Tour supports power linking for up to 12 other
COLORado™ 1 Tour fixtures at 120 VAC. Each COLORado™ 1 Tour has
NEUTRIK® powerCON connectors for Power In and Power Out. Although
the fixture comes with a power input cord, it comes with no power linking
cord.
Depending on the market and the application, the COLORado™ 1 Tour
may require an AC plug other than the Edison type. Use the table below to
install a different AC plug for the COLORado™ 1 Tour.
Connection
AC Live
AC Neutral
AC Ground
The COLORado™ 1 Tour fixture has no external fuse for the user to
change. However, it does have an internal fuse that only an authorized
CHAUVET® technician should change.
The COLORado™ 1 Tour comes with the 15° lens assembly pre-installed
from the factory. However, there is an optional lens kits (CLENS3042)
available as an accessory, which will alter the beam angle of the fixture to
30º.
To learn how to change or replace the LED lens assembly, download the
COLORado™ 1 Tour User Manual and refer to the Lens Replacement
section in the Setup chapter.
Wire (US)
Wire (Europe)
Black
White
Green/Yellow
Green/Yellow
Screw Color
Brown
Yellow/Brass
Blue
Silver
Green
Setup
5
Advertisement
Table of Contents
