Table of Contents
Advertisement
4) SYNC/HDVD SEL : Selects external synchronizing signal. (Sync in/out is according to state of EXT. SYNC
switch.)
① To synchronize this camera with the synchronizing signal of other HD-TV device.( EXT. SYNC switch
is set to IN.)
SYNC IN
•
HDVD IN(MULTI) : External synchronization with HD, VD signal(input signals from multi
•
② Synchronizing signal of this camera is output to other HD-TV device. (EXT. SYNC switch is set to
OUT)
SYNC OUT(MULTI) : Outputs the HD-TV sync signal from 13 pin of multi connector
•
HDVD OUT(MULTI): Outputs the HD/VD signal of HD-TV from 13 pin(HD) and 14 pin(VD) of multi
•
5) H PHASE : Adjustment of horizontal synchronization phase.
The phase of the image can be adjusted, when there is an input external sync signal and camera is
operating in external sync mode.
The allowable setting range is -128 to 127.
Note: There is no external synchronization, if the input external sync signal is not corresponding to
set TV system. SDTV signal can not be synchronized with external sync signal.
6) SYNC IN(BNC) : Changes input impedance of SYNC IN connector(BNC connector).
HIGH : high impedance
•
75 ohm : 75Ωimpedance
•
Note: When the camera is turned off, it becomes high impedance. So, do not use this camera in a system
which causes camera to be turned off.
: External synchronization with HD-TV sync signal(input from the SYNC IN
BNC connector).
connector(13 pin(HD), 14 pin(VD))
connector
41
Advertisement
Table of Contents
