Star Trac Turbo Trainer Owner's Manual page 15

4. Hover the console mast (Fig. 5) over the base joints and
mate the wires coming out of each component.
5. Slide the console mast (Fig. 6) over the neck joints of
the base and align the three securing bolt holes.
WARNING
To prevent any damage, verify the cable harness is
not kinked and out of the way of the brackets when
mating the console mast to the base of the
machine.
6. Install three bolts with washers (Fig. 7) thru each neck joint
hole and torque all bolts to their final value. Repeat this for
the opposite side.
Hardware
M8 x 15mm Button Head Bolt
M8 x 16mm O.D. Flat Washer
Final Torque:
18-19 Lb-Ft (24-26 Nm)
QTY
6
6
TURBO TRAINER Manufactured by STAR TRAC OWNER'S MANUAL |
Fig. 4
Fig. 5
Fig. 6
15