Star Trac Turbo Trainer Owner's Manual page 16

7. Hover the console (Fig. 8) over the neck mast and connect
the cable coming out of the mast into the cable protruding
from the console.
8. Mount the console (Fig. 9) to the frame using the four pre-
installed Phillips head screws thru each of the available
holes on the neck plate.
9. Mount the left & right grip arms (Fig. 10) onto the
corresponding pivot shafts located on the base of the
machine while mating the end of the grip arms to each of
the crank linkages and keeping the arms together by
loosely inserting a socket head cap screw with washer to
each joint.
Hardware
M8 x 20mm Socket Head Cap Screw
M8 x 25mm O.D. Flat Washer
16 | TURBO TRAINER Manufactured by STAR TRAC OWNER'S MANUAL
QTY
2
2
Fig. 7
Fig. 8
Fig. 9