Table of Contents
Advertisement
5.1.7
Packet Buffer Dimensions
5.1.7.1
TX and RX FIFO Operation
5.1.7.1.1 TX FIFO
The IXF1104 MAC TX FIFOs are implemented with 10 KB for each channel. This provides
enough space for at least one maximum size (10 KB) packet per-port storage and ensures that no
under-run conditions occur, assuming that the sending device can supply data at the required data
rate.
A transfer to MAC Threshold parameter, which is user-programmable, determines when the FIFO
signals to the MAC that it has data to send. This is configured for specific block sizes, and the user
must ensure that an under-run does not occur. Also, the threshold can be set above the maximum
size of a normal Ethernet packet. This causes the FIFO to send only data to the MAC when this
threshold is exceeded or when the End-of-Packet marker is received. This second condition
eliminates the possibility of under-run, except when the controlling switch device fails. It can,
however, cause idle times on the media.
5.1.7.1.2 RX FIFO
The IXF1104 MAC RX FIFOs are provisioned so that each port has its own 32 KB of memory
space. This is enough memory to ensure that there is never an over-run on any channel while
transferring normal Ethernet frame size data.
The FIFOs automatically generate Pause control frames to halt the link partner when the High
watermark is reached and to restart the link partner when the data stored in the FIFO falls below the
low-watermark. The RX and TX FIFOs have been sized to support lossless flow control with
9.6 KB packets. The RX FIFO has a programmable transfer threshold that sets the threshold at
which packets become "cut through" and starts transitioning to the SPI3 interface before the EOP
is received. Packets sizes below this threshold are treated as "store and forward." Once a packet
size exceeds the RX FIFO transfer threshold, it can no longer be dropped by the RX FIFO even if it
is marked to be dropped by the MAC.
5.1.8
RMON Statistics Support
The IXF1104 MAC supplies RMON statistics through the CPU interface. These statistics are
available in the form of counter values that can be accessed at specific addresses in the register
maps
(Table 59
counting from zero. A separate set of RMON statistics is available for each MAC device in the
IXF1104 MAC.
Implementation of the RMON Statistics block is similar to the functionality provided by existing
Intel switch and router products. This implementation allows the IXF1104 MAC to provide all of
the RMON Statistics group as defined by RFC2819. The IXF1104 MAC supports the RMON
RFC2819 Group 1 statistics counters.
registers supported by the IXF1104 MAC that are outside the scope of the RMON RFC2819
document.
Datasheet
Document Number: 278757
Revision Number: 009
Revision Date: 27-Oct-2005
®
Intel
IXF1104 4-Port Gigabit Ethernet Media Access Controller
through
Table
69). Once read, these counters automatically reset and begin
Table 25
notes the differences and additional statistics
80
Advertisement
Table of Contents
