Speaker Setup - Integra DSR-7.3 Instruction Manual

Speaker Setup

You need to set up the speaker configuration for the speaker
system connected to the SPEAKERS connectors
(see page 17).
Notes
• Speaker setup cannot be done if;
– Headphones are connected (see page 40)
• It is not necessary to set the parameters again once you have
completed the setup unless you change the speaker
configuration.
Selecting the number of speaker
channels
Note
To check the present setting while the normal display is displayed,
press SP Setup once. To change the setting, press the button
repeatedly within three seconds.
Press SP Setup repeatedly to select
Remote controller
only
the number of channels for the
SPEAKERS system.
SP Setup
1
Pressing the button repeatedly within three
seconds changes the number of channels
as follows (the corresponding speaker
configuration is described in parentheses):
The normal display resumes in three
seconds.
26 26
Speaker 5 (Factory setting)
ch
(Front left, center, and right, plus
surround left and right speakers)
↓
Speaker 2
ch
(Front left and right speakers)
↓
Speaker 3
ch
(Front left, center, and right speakers)
↓
Speaker 4
ch
(Front left and right, plus surround left
and right speakers)
Before operating the
remote controller
Press Mode Recvr.
Selecting the Subwoofer mode
Press SW Mode on the remote
Remote controller
controller.
only
SW Mode
4
With the first press of the button, you can
check the present setting. Then each
press of the button changes the subwoofer
mode as follows (a tip on how to select the
right subwoofer mode is in parentheses):
SW Mode 1 (Factory setting)
(When small–with limited bass signal
handling–front speakers are
connected)
↓
SW Mode 2
(When large–wideband–front speakers
are connected)
↓
SW Mode 3
(When large–wideband speakers are
connected to all channel)
↓
SW Off
(When no subwoofer is connected)
The normal display resumes in three
seconds.
Step/ Slow
C H ENTER VOL
Tun
T-D/ ST Muting
Surround A.Control
Repeat A- B
Late Night Timer
Audio Angle Subtitle FM Mode
Last M Program Random Clear
SP Setup
SP Setup Test Tone CH Sel
1 2 3
SW Mode Distance
SW Mode
4 5 6
IPM T- D Setup Up/ Down
7 8 9
+10
0 Search
-- / --- Enter
RC- 507 M