Integra DSR-7.3 Instruction Manual page 28

Speaker Setup
Adjust each speaker's relative volume balance so that the
volumes of all speakers' test tones sound equal at the
listening position.
Note
You cannot adjust the volume balance while the muting function is
activated.
Adjusting Each Speaker's Relative Volume Balance – Test Tone
1
Press Test Tone.
Each speaker emits the test tone (pink
Remote controller
noise) and the display shows the speaker
only
emitting the test tone in the following
Test Tone
order:
2
LEFT
(Front left ch.)
SUBWFR
(Subwoofer)
SURR L
(Surround left ch.)
Set voume at a level for easy comparison
of all speakers' output.
Note
No test tone will be emitted from a speaker
which is not included in the speaker
configuration on pages 26 even if it is actually
connected.
2
Press CH Sel repeatedly to select
the speaker, then press
CH Sel
Up/Down 5/∞ to adjust the volume
3
level.
The volume level can be adjusted between
–12dB and +12dB.
«
6
Up/ Down
9
28 28
→
CENTER
(Center ch.)
↑ ↓
RIGHT
(Front right ch.)
↑ ↓
←
SURR R
(Surround right ch.)
Before operating the
remote controller
Press Mode Recvr.
3
When you have completed the
adjustment by repeating step 2,
Test Tone
2 press Test Tone.
The test tone stops and the normal display
resumes.
When test tone adjustments are
completed, return the volume to its usual
level.
Note
Even if you don't press Test Tone, the test tone
will stop after two minutes.
Step/ Slow
C H ENTER VOL
Tun
T-D/ ST Muting
Surround A.Control
Repeat A- B
Late Night Timer
Audio Angle Subtitle FM Mode
Last M Program Random Clear
SP Setup Test Tone CH Sel
CH Sel
Test Tone
1 2 3
SW Mode Distance
4 5 6
Up/Down 5/∞
IPM T- D Setup Up/ Down
7 8 9
+10 0 Search
-- / --- Enter
RC- 507 M