Connecting An Fm Outdoor Antenna - Integra DSR-7.3 Instruction Manual

Connecting an FM Outdoor Antenna

If the FM reception is not very clear with the supplied antenna, connect an FM outdoor antenna instead of the indoor FM antenna .
Connecting coaxial cable to a 75/300 ohm antenna adapter (not supplied)
1 Strip the end of the coaxial cable.
15 mm
6 3 6
mm mm mm
1 1 1
/ / /
4 8 4
in. in. in.
5
/ in.
8
2 With your fingernail or a small
screwdriver, press the stoppers
outward and remove the cover.
Notes
• Install the antenna well away from tall buildings and in an area where FM stations can directly be received.
• Keep the antenna away from noise sources (neon signs, busy roads, etc.).
• It is dangerous to put the antenna close to power lines. Keep it well away from power lines, transformers, etc.
• To avoid the risk of lightning and electrical shock, grounding is necessary. Follow item 14 of the "Important Safety Instructions" on page 2 when
you install the outdoor antenna.
Directional Iinkage
Do not use the same antenna for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can interfere with each
other. If you must use a common FM/TV (or VCR) antenna, use a directional linkage type splitter.
To DVD Receiver
3 Remove the transformer wire A
from slit B and insert it into slit C.
Slit C
4 Insert the end of the cable.
5 Clamp it in place with pliers.
5
6 Reinstall the cover.
Directional linkage
type splitter
To TV (or VCR)
ANTENNA
Slit B
AM
Wire A
Connecting 300 ohm ribbon
wire to a 75/300 ohm
antenna adapter*
Loosen the screws and wrap
the wire around these screws.
4
Then tighten the screws with
a screwdriver.
Tighten
FM outdoor antenna
FM 75
Loosen
23 23