Integra DSR-7.3 Instruction Manual page 14

Index to Parts and Controls
Rear panel
Shapes of jacks vary depending on the area in which it was
purchased.
1 SUB WOOFER PRE OUT jack [17, 18]
This terminal is for connecting an active subwoofer.
2 TV/LINE IN jacks [16,19]
This terminal is for connecting audio output terminals of TV, VCR or
other video equipment.
3 MD/CDR/TAPE IN/OUT jacks [19]
These terminals are for connecting to the recording input and
output terminals of an MD recorder, CD recorder or tape deck.
4 z REMOTE CONTROL connector [20]
Connect the Integra/Onkyo components that have
such as a MD recorder, and cassette tape deck using the
cables provided with them. When these components are
interconnected, they can be controlled from the remote controller
provided with the DVD Receiver.
After connecting the
remote controller buttons for use in controlling other components.
5 IR IN jack [21]
If the DSR-7.3 is located inside a rack or cabinet that will not allow
infrared beams to reach the IR sensor, you will need to connect a
remote sensor to IR IN jack to be able to use the remote controller.
Then install the remote sensor in an unblocked location where you
can easily point the remote controller.
14
1 2 3 4 5
L
PREOUT
IR
AUDIO
REMOTE IN
CONTROL
R
SUB IN OUT IN
WOOFER TV/LINE MD/CDR/TAPE
DIGITAL VIDEO OUTPUT
Y
OPTICAL
OUT IN S VIDEO VIDEO COMPONENT
9 0
z connectors, check the operation of the
6
ANTENNA
ANTENNA
AM FM 75
P P
B R
6 ANTENNA terminals [22, 23]
These terminals are for connecting the FM antenna and AM
antenna.
7 FRONT SPEAKERS, CENTER SPEAKER and SURROUND
SPEAKERS terminals [18]
Speaker terminals are provided for the front left, front right, center,
surround left and surround right speakers.
8 AC INLET [24]
Connect supplied AC power cord to this terminal.
9 DIGITAL OPTICAL IN/OUT jacks [16, 19]
These are the digital audio input and output jacks. The digital input
works in combination with the analog TV/LINE IN jacks. Connect
z
connectors
the digital output from your TV or satellite tuner (MD player, etc.) to
z
DIGITAL OPTICAL IN. Set the Input Selector to TV/LINE IN to play
the digital sound. Connect the DIGITAL OPTICAL OUT to a digital
recording device (MD recorder, CD recorder, etc.). Do not connect
the DIGITAL OPTICAL OUT if the digital output from the same
component is connected to the DIGITAL OPTICAL IN.
0 VIDEO OUTPUT (VIDEO/S VIDEO/COMPONENT) jacks
[16]
The monitor output includes RCA type, S video and component
configurations. This output is for connecting television monitor or
projector.
7
SURROUND
FRONT SPEAKERS
SPEAKERS
R L R L
CENTER
8
AC INLET