Speaker Setup - Integra DTR-50.6 Advanced Manual

2.Speaker Setup

Allows you to change the speaker configuration such as presence or not of subwoofer,
crossover frequency, and so on. Settings are automatically configured if you use the
Automatic Speaker Setup.
Furthermore, this setting cannot be selected if headphones are connected or audio is
output from the speakers of the TV.
Speaker Settings
Change the impedance of the connected speakers, the type of front speaker connection
and height speaker type.
Setting Item Default Value Setting Details
Speaker 6ohms Set the impedance of the connected speakers.
Impedance "4ohms": When any of the connected speakers have
or more impedance
Front Speakers Normal Select the type of front speaker connection.
Type "Normal": When front speakers are connected in a
normal manner
"Bi-Amp": When front speakers are bi-amp
connected
Height Speakers Not Use Set the type of speakers connected to SPEAKERS
Type HEIGHT/Bi-AMP speaker terminals. Select from the
following options according to the type and layout
of the connected speakers: "Not Use", "Front High",
"Top Front", "Top Middle", "Dolby Enabled Speaker
(Front)", "Dolby Enabled Speaker (Surround)", or
"Dolby Enabled Speaker (Back)".
If "Front Speakers Type" is set to "Bi-Amp", this
setting will be set to "Not Use".
"Dolby Enabled Speaker (Surround)" cannot be
selected if "Speaker Configuration" - "Surround"
is set to "None".
"Dolby Enabled Speaker (Back)" cannot be
selected if "Speaker Configuration" - "Back" is set
to "None" or "Back ch" is set to "1ch".
Setting Item Default Value Setting Details
Powered Zone 2 No Set presence of speaker terminal connection of
Zone 2.
"Yes": When speakers are connected to ZONE 2
speaker terminals
"No": When speakers are not connected to ZONE 2
speaker terminals
For impedance, check the indications on the back of the speakers or their instruction manual.
Speaker Configuration
Allows you to change the speaker configuration such as presence or not of each speaker,
crossover frequency, and so on. Settings are automatically configured if you use the
Automatic Speaker Setup. Audio will not be output while you are making this setting.
Setting Item Default Value Setting Details
Subwoofer Yes Set whether a subwoofer is connected or not.
"Yes": When subwoofer is connected
"No": When subwoofer is not connected
Front 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
Center 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
Advanced Settings
If "Front Speakers Type" is set to "Bi-Amp", this
setting will be set to "No".
"Front" will be fixed to "Full Band" if "Subwoofer"
is set to "No", and the bass frequencies of the
other channels will be output from the front
speakers. To make the settings, refer to the
instruction manual of the speakers used.
"Full Band" can only be set if "Front" is set to "Full
Band".
25