Table of Contents
Advertisement
Setting a Blood Pressure Target (optional)
If targeted measurement values have been recommended by a
doctor, set a blood pressure target to give a realistic reading based
on these recommendations. Open
save the «Systolic» and «Diastolic» targets.
After completing these steps, you are ready to take a blood pressure
measurement.
Note: Confirm that the time and date on your iOS device are correct.
Taking Measurements with the
Microlife Cardio+
Before Taking a Measurement
• Avoid any activity, eating, or smoking immediately before taking a
measurement.
, and go to «Settings». Set and
• Sit down and relax for at least 5 minutes before taking a
measurement.
• Always take measurements on the same arm (normally the left).
• Remove close-fitting clothing from the upper arm. To avoid
constriction, your shirt sleeve should not be rolled up; it will not
interfere with the cuff if it is laid flat.
• Fit the cuff closely, but not too tightly. Make sure that the cuff is
2 cm (0.75 inches) above your elbow, with the tube on the inside of
your arm.
2 cm (0.75 inches)
• Support your arm so that it is relaxed. Ensure that the cuff is at the
same height as your heart.
Relax 5 mins
6
EN
Advertisement
Table of Contents
