Table of Contents
Advertisement
Item
Pin Code
Configure via Push
Button
Configure
via
Pin
Code
below will transfer gray scale to black scale. Configure the setting
consistent with the setting on the wireless router/AP that this IP
camera will join the wireless network. Apply the settings then check
the wireless networking.
Description
Here displays the WPS pin code used to connect to WPS-enabled
wireless access points. You have to input this number into the WPS
enabled access point to establish WPS connection.
Click this button and this camera will enter PBC-style WPS connection
state for 120 seconds. Please push "Start PBC" button on the
wireless access point you wish to connect within 120 seconds to
establish WPS connection (The remaining time will be displayed on the
button). If connection can not be established after 120 seconds, you'll
be prompted by a message box, and you can press "Start PBC"
button to try again.
If you have wireless access point's WPS PIN code, you can input it
here and press "Start PIN" button to start to establish PIN-style WPS
connection.
49
Advertisement
Table of Contents
