Planet ICA-HM227W Network Setup

VERIFY THE CONTENTS INSIDE PACKAGE BOX
The package should contain the items plus ICA-HM227W. If any item is missing or damaged, please contact the seller immediately.
Quick Installation Guide
Step 1 : Please follow the following instructions to set up the camera
Connect the Ethernet cable to

your local area network, and
connect the other end to the LAN
jack of this IP camera.
DC 12V
DI/DO
Reset/WPS
Audio Out
LAN
SD
Remark : If you wish to hang the camera on the ceiling or wall, please place the IP camera at a secured place, and point the camera to the place
you wish to monitor. The way to install this camera please refer the user manual in CD-ROM.
Step 2 : Computer Network Setup
Set your computer's IP address to 192.168.0.x, where x is an integer between 1 to 254 (except 20
where is being used for the camera by default).
Step 3 : Login Prompt
Use web browser (Internet Explorer 6.0 or above) to connect to 192.168.0.20 (type this address in
the address bar of web browser).
You'll be prompted to input user name and password: admin / admin
Quick Guide
CD-ROM Antenna x 1
Plug the power adapter to wall

socket and connect the power
connector to the power jack
located at the back of the IP
camera.
DC 12V
DI/DO
Reset/WPS
Audio Out
SD
Power Adapter
Connect the antennas to the

antenna base located at the back
of the IP camera.
Audio Out
LAN
ICA-HM227W
x 4
x 1
x 4
x 3
Camera Mounting Kit
DC 12V
DI/DO
Reset/WPS
LAN
SD