Timer Operation; Wake-Up Timer; Maintenance - Sanyo DC-UB1475M Instruction Manual

TIMER OPERATION

Wake-up timer

Set the on and off time, the unit will turn on and start the selected
function automatically at the on time, and will turn off when the off time
arrives.
The timer will function every day unless it is released.
Preparations
Make absolutely sure that the clock is set to the correct time before
setting the timer.
- Prepare the source to be used.
- Adjust the tuner or band of radio if choosing "TUNER".
- Place the disc in advance if choosing "CD".
- Connect the USB memory device in advance if choosing "USB".
- Insert the SD card if choosing "CARD".
For example:Waking up at 7:30 every day and listening to the CD until
8:15.
1. Turn on the power and press the TIMER button. "SELECT
SOURCES" scrolls on the display.
2. Press the FUNCTION button to select "CD".
3. Press the TIMER button. Volume level blinks on the display. Press
the VOLUME + or - button to select the volume.
4. Press the TIMER button. "SET ON TIMER" scrolls on the display.
5. Press the TIMER button again. The hour section of the preset on-
time blinks on the display.
6. Press the e or f button to set the hours.
7. Press the TIMER button. The minute section blinks on the display.
8. Press the e or f button to set the minutes.
9. Press the TIMER button. "SET OFF TIMER" scrolls on the display.
10. Repeat above steps 5-8 to set off time.
11. Press the TIMER button to complete the setting. Original function
retuns.Then turn off the power. The clock time appears and
remains lit.
Note:
- The preset function starts when the timer on-time arrives.
The volume increases gradually to the preset level.
- When the timer off-timer arrives, the power turns off and the timer is
set to the standy mode. Timer operation repeats everyday.
To release the timer
In power on mode, press the TIMER button once,
Or in power off mode, press the z/STANDBY button to turn on the unit.
disappears.
Sleep timer (Remote control only)
The sleep timer automatically switches off the power after a preset time
has elapsed. There are 9 time periods available: 90, 80, 70, 60, 50, 40,
30, 20, and 10 minutes.
Press the SLEEP button repeatedly to select the desired sleep time.
After several seconds, the original display returns, "
To release the sleep timer while in operation
Press the SLEEP button repeatedly to select "OFF", "
from the display. The timer is also released if the power is switched off.

MAINTENANCE

Cleaning the tape heads (Fig. 12)
To ensure continued high performance, use cotton swab to clean the
heads, pinch roller and capstan of the decks after about every 10 hours
of use. If the dirt persists, soak the swab in a little methylated spirit or
head cleaning fl uid and then clean.
Cleaning the CD player lens
The lens should never be touched. If dust is on the lens, blow it off using
a camera lens blower (Fig. 13). (Consult your dealer.)
Cleaning the unit
Clean the outside of the unit with a clean soft cloth, moistened with
lukewarm water. Do not use benzene, thinner or alcohol since they will
mar the fi nish of the surfaces.
disappears.
16
z
" remains lit.
z
z
" disappears
z