Ports On The Device; Connecting A Monitor - Fujitsu Esprimo E5 Series Operating Manual

Getting started

Ports on the device

Device, Externaldevices, Interfaces
The ports are located on the front and back of the device. The ports available on your
device depend on the configuration level you have selected. The standard ports are
marked with the symbols shown below (or similar). Detailed information on the location
of the ports is provided in the manual for the mainboard.
Serial interface, turquoise
Serialinterface
VGA monitor port, blue
Monitorport
Headphones, pale green(rear
of device) or black (front of
device)
Headphones
USB - Universal Serial Bus,
black
UniversalSerialBus
PS/2 mouse port, green
PS/2mouseport Mouseport
DVI-I monitor port
Some of the connected devices require special drivers (see the
documentation for the connected device).

Connecting a monitor

► Follow the instructions contained in the monitor manual to prepare the monitor
for operation (e.g. connecting cables).
Monitor
► Connect the data cable of the monitor into the required monitor port of your device.
The monitor connector on the device is only approved for use with monitors that
have a rated current less than or equal to 1.0 A at 230 V or less than or equal to
2.0 A at 100 V. The values for the monitor current consumption can be found in the
technical data for the monitor or in the operating manual for the monitor.
► Depending on the configuration level of your device, plug the monitor power
cable into the grounded mains outlet.
18
Microphone port, pink (rear of device) or
black (front of device)
Microphoneport
Audio input (Line In), light blue
Linein Audioinput
Audio output (Line Out), light green
Lineout Audiooutput
LAN port
LAN
LANport
PS/2 keyboard port, purple
Keyboardport
DP DisplayPort
Fujitsu