Ports On The Device; Connecting The Mouse - Fujitsu ESPRIMO K5010 Operating Manual

Ports on the device

Externaldevices Device Ports
The ports are located on the front and rear of the device. The ports available on
your device depend on the configuration level you have selected. The standard ports
are marked with the symbols shown below (or similar).
DP DisplayPort
DisplayPort
Audio output (Line Out)
Audiooutput Lineout
Audio input (Line In)
Audioinput
PS/2 mouse port, green
PS/2mouseport
USB 2.0 - Universal Serial
Bus, black
UniversalSerialBus
Some of the connected devices require special software (e.g. drivers) (refer to the
documentation for the connected device and operating system).

Connecting the mouse

A USB mouse or a PS/2 mouse can be connected to your device (if the PS/2 option
consisting of a PS/2 mouse and keyboard port was selected).
Connecting, Mouse,
Connecting a USB mouse
► Connect the USB mouse to one of the USB ports on the device.
USBport USBport,
Connecting a PS/2 mouse (optional)
The PS/2 mouse is only detected by the device if you connect the mouse when
the device is switched off and then switch the device on again.
► Connect the PS/2 mouse to the PS/2 mouse port of the device.
PS/2mouse, Connecting, PS/2mouse,
► Switch your device on again.
Fujitsu
LAN port
LANport
Headset jack
Headsetjack
Serial port
Serialport
PS/2 keyboard port, purple
PS/2keyboardport
USB 3.2 - Universal Serial Bus, type A:
blue, type C: black (depending on the
device)
Getting started
21