Important Notes; Safety Information; Transporting The Device - Fujitsu Esprimo E5 Series Operating Manual

Important notes

Important notes
Notes Importantnotes
In this chapter you will find information regarding safety which it is essential to
take note of when working with your device.

Safety information

Note Safetyinformation
Please note the information provided in the "Safety/regulations" manual
and in the following safety notes.
When installing and operating the device, please observe the notes on
environmental conditions in Chapter
as the instructions in Chapter
When setting up the device, make sure there is clearance all around it so that
the casing receives enough ventilation. In order to avoid overheating, do not
cover the ventilation areas of the monitor or the device.
You must only operate the device if the rated voltage used by the
device is set to the local mains voltage.
The main switch (if present) and the ON/OFF switch do not disconnect the
device from the mains voltage. To completely disconnect from the mains
voltage, remove the power plug from the power socket.
Replace the lithium battery on the mainboard in accordance with the instructions
"Replacing the lithium battery", Page
in
Caution, components in the system can get very hot.
The activities described in these instructions must always be
performed with the greatest care.
Repairs to the device must only be performed by qualified technicians.
Incorrect repairs could put the user at great risk or cause serious damage
to the equipment (electric shock, risk of fire).

Transporting the device

Retransportation Transportation Device,
Transport all parts separately in their original packaging or in a packaging which
protects them from knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold environment into the room where it will be used,
condensation may occur. Before operating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the installation site.
10
"Technical specification", Page 66
"Getting started", Page
65.
as well
13.
Fujitsu